Home > Five Simple Steps To Uninstall And Install A Boat Propeller
We Have Found 2 Products for your search of Five Simple Steps To Uninstall And Install A Boat Propeller.
Displaying Items Page 1 and Articles Page 1.
|
| Please vote and
rate this. |
Five Simple Steps To Uninstall And Install A Boat Propeller
by Victor Epand
Sometimes things go wrong with boats. You can't explain how it happened... it just did. You could be using it one day and it suddenly breaks down. You may be getting ready to use it and it just doesn't crank. Anything can happen to the boat. This is true for your boat's propeller as well. However, replacing the propeller doesn't have to be a difficult task as long as you know what you are doing or learn how to do it properly.
Be sure you find the propeller you get will fit your boat. Certain propellers will fit certain boats. You don't want to spend money only to find out that it is the wrong propeller. Use your boat's handbook to help you identify which propeller is right for you. You may find out that you are not limited to a certain propeller type.
Check the propeller's pitch and diameter so that they match the boat's engine. When you have the right propeller, your boat will have the power it needs to get going.
Now that you have the propeller you need, here are some steps to help you remove your old one and replace it with a new one. Don't forget to have tools on hand to help you out.
Five Steps To Replace Your Boat Propeller
Don't remove the prop shaft nut completely just loosen it. You don't want the propeller to go back into the rudder when you get it separated from the shaft. Once you have it loose, then take the nut and washer off.
If it seems you are having some trouble, put some oil onto it and wait to the next day to try messing with it again. If that doesn't seem to do the trick, use some sort of heating device to help loosen it. Try not to scorch anything else while you are doing this trick.
You don't want to use hammers on a boat to make something fit or come off. Hammer vibrations can be sent into the boat's transmissions.
Now that you have the propeller off, be sure to inspect the area for fishing line or anything else that could have gotten caught in it. Inspect all the parts of the boat propeller as well including the nuts and washers.
It's time to replace it with a new one. Be sure you slide it up onto the shaft. When it's on there correctly, you should get a solid smacking sound. Don't use the nut to get it back into place. Use a wrench to tighten it. Above all else, that nut needs to be tight to avoid losing your propeller when it is in use.
Be sure you check your propeller each year for signs of wear and tear. Nothing is worse than being stuck in the middle of the ocean with no propeller.
Some boats may have slightly different parts that hold up a propeller. Should you have any further problems, ask a professional or take a look at your boat's instructional manual for guidance.
About the Author
Victor Epand is an expert consultant about model boats, boat parts, and model submarines. You will find the best shopping at these sites for model boats, used boat propeller, and model submarines.
Have you ever wanted to turn your 3D designs into reality? Enter Shapeways! Just upload your design, we print it and ship it to you - it's easy. Within ten working days you'll hold your own design in your hands. Website: www.shapeways.com
|
| 
